Alpine CDA-7894 CD Player User Manual


 
37-EN
Installation
Caution
When you install this unit in your car, do not remove the
Detachable Front Panel.
If the Detachable Front Panel is removed during installation,
you might press too hard and warp the metal plate that holds it
in place.
1
Slide the mounting sleeve into the dashboard.
2
Reinforce the head unit with the metal mounting strap (not
supplied). Secure the ground lead of the unit to a clean
metal spot using a screw (
) already attached to the
vehicle's chassis.
NOTE
For the screw marked
**
, use an appropriate screw for the
chosen mounting location.
Metal plate
Detachable
Front panel
Mounting Sleeve
(Included)
Dashboard
CDA-7995/CDA-7894/CDA-7893/CDA-7892
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming from the
left rear of the CDA-7995/CDA-7894/CDA-7893/CDA-7892.
Connect all other leads of the CDA-7995/CDA-7894/CDA-
7893/CDA-7892 according to details described in the
CONNECTlONS section.
Slide the CDA-7995/CDA-7894/CDA-7893/CDA-7892 into
the dashboard. When the unit is in place, make sure the
locking pins are fully seated in the down position. This can
be done by pressing firmly in on the unit while pushing the
locking pin down with a small screwdriver. This ensures that
the unit is properly locked and will not accidentally come
out from the dashboard. Install the Detachable Front Panel.
Removal
1 Remove the DETACHABLE FRONT PANEL.
2 Use a small screwdriver (or similar tool) to push the
locking pins to the “up” position (see above drawing). As
each pin is unlocked, gently pull out on the unit to make
sure it does not re-lock before unlocking the second pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Face Plate
NOTE
Secure the ground lead of the unit to a clean metal spot using a
screw (
) already attached to the vehicle's chassis.
3
Lock Pin
Mounting Bracket
Ground Lead
Screws (M5 × 8)
(Included)
CDA-7995/
CDA-7894/
CDA-7893/
CDA-7892
Metal
Mounting
Strap
Chassis
Hex Nut (M5)
Bolt Stud
Ground Lead
∗∗
CDA-7995/
CDA-7894/
CDA-7893/
CDA-7892
Screw