Filter
Top Products
7-EN
Basic
Adjusting Source Signal Level
If the difference in volume level between the CD
player and FM radio is too great, adjust the FM
signal level as follows.
1 Press and hold the SETUP button for at least 3
seconds.
2 Press the f UP button repeatedly to select
"FM-LV."
Each press of the f UP button scrolls the
modes as follows:
∗ CDA-7873R/TDA-7587R Only
NOTE
When you press the g DN button, the display scrolls
in the reverse sequence.
3 Press the TUNE button to select the FM signal
level mode. Each press toggles between "FM-LV
HI" (High) and "FM-LV LO" (Low).
4 Press the SETUP button to activate the normal
mode.
Changing Backlighting Colour
CDA-7873R/TDA-7587R only
1 Press and hold the SETUP button for at least 3
seconds.
2 Press the f UP button repeatedly to select
"AMBER".
Each press of the f UP button changes the
modes as shown:
NOTE
If you press the g DN button the display scrolls in
reverse sequence.
∗ CDA-7873R/TDA-7587R Only
3 Press the TUNE button to toggle the mode
between "AMBER ON" (amber) and "AMBER
OFF" (green).
4 Press the SETUP button to set the selected
mode.
Adjusting Volume/Balance
(Between Left and Right)/Fader
(Between Front and Rear)
1 Press the MODE (Audio Control) knob
repeatedly to choose the desired mode.
Each press changes the modes as follows:
NOTES
• If the MODE (Audio Control) knob is not rotated
within 5 seconds after selecting the BALANCE, or
FADER mode, the unit automatically returns to the
VOLUME mode.
• When the subwoofer or BBE mode is ON, their
respective levels may be adjusted.
2 Rotate the MODE (Audio Control) knob until the
desired sound is obtained in each mode.
NOTE
When the temperature inside the unit rises, the volume
may decrease momentarily. This is not a malfunction.
Selecting BBE Mode
The BBE (Barcus Berry Electronics) processor
installed in this unit is designed to correct the
phase distortion inherent in most loudspeaker
designs. Ensuring the phase integrity of the signal
driving the speakers improves the accurate
reproduction of the sound.
1 Press and hold the BBE button for at least 2
seconds to turn on and off the BBE mode.
2 In BBE mode, press the MODE (Audio Control)
knob to select the BBE adjusting mode.
Each press changes the adjusting mode.
3 To change to a desired BBE level, rotate the
MODE (Audio Control) knob.
The BBE level can be changed from +1 to +3.
NOTE
The initial mode is +2.
→ BAL → FAD → VOL
→ FM-LV → REG → PTY31 → HI-FI/NORMAL/STABLE → AMBER
∗
DEMO ← AUX ← SCR ← MUTE ← BEEP ← SUB ← DIM ←
→ FM-LV → REG → PTY31 → HI-FI/NORMAL/STABLE → AMBER
∗
DEMO ← AUX ← SCR ← MUTE ← BEEP ← SUB ← DIM ←