Filter
Top Products
18-EN
RDS
Recalling Preset RDS Stations
1 Press the "F" button. The indicator will
illuminate.
2 Press the AF button to activate the RDS mode.
The display shows "AF" when the RDS mode is
activated.
3 Press the 1 through 6 buttons in which your
desired RDS station is preset. If the preset
station's signal is weak, the unit automatically
searches and tunes to a stronger station in the
AF (Alternative Frequencies) list.
4 If the preset station and the stations in the AF list
cannot be received:
The unit searches again for a station in the PI
(Programme Identification) list.
If there are still no stations receivable in the
area, the unit displays the frequency of the
preset station and the preset indicator
disappears.
If the signal level of the Regional (Local) station
being tuned becomes too weak to receive, press
the same preset location button to tune in a
Regional station in other district.
NOTE
For presetting the RDS stations, refer to the Radio
Operation section. The RDS stations can be preset in the
FM1, FM2 and FM3 bands only.
RDS Operation
Receiving RDS Regional (Local)
Stations
1 Press and hold the SETUP button for at least 3
seconds to activate the setting mode.
2 Press the f UP button repeatedly to select
"REG" Each press of the f UP button scrolls
the modes as shown:
∗ CDA-7873R/TDA-7587R Only
NOTE
If you press the g DN button the display scrolls in
reverse sequence.
3 Press the TUNE button to turn on or off the
"REG" (Regional) mode.
In the "REG OFF" mode, the unit automatically
keeps receiving the related local RDS station.
4 Press the SETUP button to deactivate the setting
mode.
TUNE T.INFO
SETUP/F AF
Preset buttons (1 through 6)
PTY
g DN
f UP
→ FM-LV → REG → PTY31 → HI-FI/NORMAL/STABLE → AMBER
∗
DEMO ← AUX ← SCR ← MUTE ← BEEP ← SUB ← DIM ←