Filter
Top Products
21-EN
RDS
4 Press the P. PTY button to activate the
PRIORITY PTY mode again.
• To change the programme category, perform
the step 3.
• To disable the PRIORITY PTY function, press
the P. PTY button.
NOTE
In the PRIORITY PTY function, unlike in the T.INFO
function, the volume does not increase during operation.
5 Press the "F" button to activate the normal mode.
The
indicator will turn off.
NOTE
Operate the unit while the indicator is illuminated.
If no buttons are pressed within 5 seconds, the
indicator will turn off.
Turning Emergency Alarm On or Off
1 Press and hold the SETUP button for at least 3
seconds.
2 Press the f UP button repeatedly to select
"PTY31" Each press of the f UP button
scrolls the modes as shown.
∗ CDA-7873R/TDA-7587R Only
NOTE
If you press the g DN button the display scrolls in
reverse sequence.
3 Press the TUNE button repeatedly to select the
"PTY31 ON" or "PTY31 OFF" mode.
In the PTY31 ON mode, the unit will show
"ALARM" in the display when the unit receives
the PTY31 (Emergency Broadcast) signal.
4 Press the SETUP button to activate the selected
mode.
Displaying Radio Text
Text messages from a radio station can be
displayed.
1 Tune in a radio station that transmits text
messages.
2 Press the "F" button. The indicator
illuminates.
3 Press the R.TEXT button to activate the Radio
Text mode. The display shows "WAIT" for a few
seconds, then starts scrolling the text message.
It continues until other operation is performed.
4 To cancel the Radio Text mode, press the
R.TEXT button.
5 Press the "F" button to return to the normal
operation mode. The
indicator disappears
from the display.
NOTES
• If there is no receivable text message or the unit
cannot receive a text message properly, the display
shows "NO TEXT" for 2 seconds.
• Operate the unit while the
indicator is
illuminated.
If no buttons are pressed within 5 seconds, the
indicator will turn off.
→ FM-LV → REG → PTY31 → HI-FI/NORMAL/STABLE → AMBER
∗
DEMO ← AUX ← SCR ← MUTE ← BEEP ← SUB ← DIM ←