Filter
Top Products
I
BEFORE OPERATION
SETTING THE CLOCK
POWER – -@l
DEMO
Function
PHONES
m
U - sensor
Remote
,.-,
—........
To turn the unit on
Press one of the function buttons (TAPE, TUNER, VIDEO/AUX,
CD, MD).
Playback of the inserted disc or tape begins, or the previously
tuned station is received (Direct Play Function).
The POWER button is also available.
The disc compartment may open and close to reset the unit.
Illumination guides
Whenever the AC cord is connected or one of the function buttons
is pressed, the buttons for that operation light up or flash.
Example: When the AC cord is connected, the II button flashes
as a guide to setting the current time.
After use
Press the POWER button to turn off the power. The display
changes to the clock.
MULTI JOG dial
The MULTI JOG dial can be used when tuning in to a preset
station or skipping to the beginning of a CD track. it can also be
used with the MODE button as a convenient dial to adjust the
sound quality and turn Dolby NR on or off. Refer to pages 6, 8,
9, and 11 for details.
Using the headphones
Connect headphones to the PHONES jack with a stereo mini
plug (03.5 mm, l/s inch).
No sound is output from the speakers while the headphones are
plugged in.
““m
1
2
3
4
5
6
II
1“””””””’”~
Ej
– CLOCK
–SHIFT
–44, -
- II
Press the CLOCK button while pressing the
SHIFT button on the remote control.
Within 4 seconds, press the 11 button.
The hour flashes.
To switch to the 24-hour standard, press the
■ button.
To restore the 12-hour standard, press the
■ button again.
Press the < or W button or turn the MULTI
JOG dial to designate the hour.
Press the 11 button to set the hour.
The hour stops flashing and the minute starts flashing.
Press the + or * button or turn the MULTI
JOG dial to designate the minute.
Press the II button to set the minute and
complete setting.
The minute stops flashing on the display and the clock starts
from 00 seconds.
To set the clock without the remote control
1 Turn off the unit
if the unit is powered. Then, if
the demonstration display appears, press the
DEMO button to cancel it.
2 Press the 1I button twice so that the hour flashes.
Carry out then the steps 3 to 6 above.
To display the current time
Press the CLOCK button while pressing the SHIFT button on
the remote control. The time is displayed for 4 seconds.
However, the time cannot be displayed during recording.
If the clock display flashes while the power is off
This is caused by a power interruption. The current time needs
to be reset.
If
power is interrupted for more than approximately 12 hours, all
settings stored in memory after purchase need to be reset.
5 ENGLISH