Filter
Top Products
TROUBLESHOOTING GUIDE
Iftheunit fails toperform as described in these operating
instructions, check the following guide.
GENERAL
There is nosound.
● Is the AC cord connected properly?
● 1sthere a bad connection? (+ page 10)
● There may be a short circuit in the speaker terminals.
+ Disconnect the AC cord, then correct the speaker
connections.
● Was an incorrect function button pressed?
Sound is emitted from one speaker only.
● Is the other speaker disconnected? (+ page 10)
TUNER SECTION
There is constant,wave-likestatic.
● Isthe antenna connected properly? (+ page 10)
● Is the signal weak?
+ Install an outdoor antenna. (+ page 10)
The reception contains noise interferences or the sound is
distorted.
● Is the system picking up external noise or multipath distortion?
+ Change the orientation of the antenna. (+ page 8)
+ Move the unit away from other electrical appliances.
CASSETTE DECK SECTION
The tape
does not run.
● Is the deck in pause mode? (+ page 28)
The sound is off-balance or not adequately high.
● Is the playback head dirty? (+ page 36)
Recording is not possible.
● Is the erasure prevention tab on the tape broken off? (+ page
28)
● Is the recording head dirty? (+ page 36)
High frequency sound is not emitted.
● Is the recording/playback head dirty? (+ page 36)
CD PLAYER SECTION
The CD player does not play.
c Is the disc correctly inserted? (+ page 22)
● Is the disc dirty? (+ page 36)
● Is the lens affected by condensation?
+ Wait approximately one hour and try again.
To reset
If an unusual condition occurs in the display window or the
cassette decks, reset the unit as follows.
1 Press the POWER button to turn off the power.
2 Press the POWER button to turn the power back on while
pressing the
■ CLEAR button. Everything stored in memory
after purchase is canceled.
If the power cannot be turned off in step 1 because of a
malfunction, reset by disconnecting the AC cord and repeat
step 2.
40