Filter
Top Products
A
H
BASIC OPERATIONS
INSERTING TAPES
● You can select a reverse mode to play back one or both sides.
● Use normal (type I), Crop (type II) or metal (type IV) tapes for
playback.
Press the TAPE button and press the A EJECT mark
to open the cassette holder. -+
❑
Insert a tape with the exposed side down and with the side to be
played first facing out from the unit. Push the cassette holder to
close.
To select a reverse mode + ❑
Each time the TAPE/REV MODE button is pressed, the reverse
mode changes.
To play one side only, turn on =.
To play from front side to back side once only, turn on 3.
To play both sides repeatedly, turn on (:).
PLAYING BACK A TAPE
Insert a tape,
Press the <- button to start play. -+ ❑
DISPLAY
@
Playback side of the tape
b: The side facing out from the unit (the front side) is being
played.
+: The side facing in toward the unit (the back side) is being
played.
@ Tape counter indicates the tape running length.
To stop play, press the
■ button.
To pause play, press the II button. To resume play, press again.
To change the playback side, press the <b DIR/PRESET
button in play or pause mode.
To fast forward or rewind, press the 44 or - button in stop
mode. Then press the
■ button to stop the tape.
To start play when the power is off (Direct Play Function)
Press the TAPE button. The power is turned on and play of the
inserted tape begins.
To set the tape counter to 0000
Press the 9 CLEAR button in stop mode.
The counter is also set to 0000 when the cassette holder is
opened.
About cassette tapes
c
To prevent accidental erasure, break off the plastic tabs on
the cassette tape after recording with a screwdriver or other
pointed tool. +
❑
@Side AJ @ Tab for side A
To record on the tape again, cover the tab openings with
cellophane tape, etc.
● 120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
● Take up any slack in the tape with a pencil or similar tool before
use. Slack tape may break or jam in the mechanism. +
❑
28