Filter
Top Products
@q
,/+ ~
e~
,.
-..’. ..
,:
..’,-..;.-,’
,. ..,’,..
..
)
d
-%
‘+!
/
PRECAUTIONS
Follow the advice below for safe and correct operation.
This system may be powered by an AC voltage or car battery
(DC 12 V) power source. (Car battery cord is not supplied.)
On AC voltage
Before connecting the AC cord, check that the rated voltage
shown on the rear panel matches your local voltage.
For LH model
AC 120/220-240 V, selectable.
To match your local voltage, switch the AC VOLTAGE selector
on the rear panel with a screwdriver or similar tool. +
❑
For U model
AC 120 V, fixed,
For K model
AC 230 V, fixed.
On placement
● Do not use the system in places which are extremely hot, cold,
dusty or humid.
● Do not use the system in places which are subject to vibration.
● Place the system on a flat, even surface.
● The unit should be situated with adequate space around it so
that proper heat ventilation is assured. Allow 10 cm (4 in.)
clearance from the rear and the top of the unit, and 5 cm (2 in.)
from each side.
In particular, do not place the system in an airtight rack.
● If using the system near a television or radio, noise may be
heard from the television, radio or this system. Move this system
away from the affected television or radio.
On safety
● When disconnecting the AC cord or car battery cord, pull out
by the plug. Do not pull the cord itself.
● When the system is not used for an extended period of time,
disconnect the AC cord or car battery cord. When the cord is
plugged in, a small amount of current continues to flow to the
system, even when the power is turned off.
● If the AC cord is damaged, contact your dealer or an Aiwa
service center for immediate replacement or repair.
Should any trouble occur, disconnect the AC cord and car battery
cord and contact a qualified service representative.
CONNECTIONS
IMPORTANT
.
Make sure the AC voltage matches your local voltage. (LH
model only)
● Connect the AC cord or car battery cord after connecting
speakers, antennas, and all optional equipment.
● There are no differences between the speakers. Both speakers
can be connected as L (left) or R (right).
To stand the AM antenna + H
Fix
the claw to the slot,
To position the antennas
FM feeder antenna: (For U and LH model only)
Extend this antenna horizontally in a T-shape and fix its ends to
the wall with cellophane tape, etc.
FM unipolar antenna: (For K model only)
Extend fully and position for the best possible reception.
This antenna is of an instant type, so the use of an outdoor
antenna is recommended.
AM (MW/LW)
loop antenna:
Position to find the best direction and position for radio reception.
8