Filter
Top Products
En
ENGLISH
7
1
Press ECO.
“ECO MODE” will be displayed.
2
Press ENTER within 4 seconds.
The current power-economizing mode status will be displayed.
3
Turn MULTI JOG within 4 seconds to select one
of the power-economizing mode.
Example: When “ECO ON” is selected.
4
Press ENTER within 4 seconds.
If the clock is not set, the unit does not black out.
Instead, the DEMO will begin when the power is turned off.
DIMMER MODE
To change the display dimmer mode
1 Press ECO repeatedly until “DIM MODE” is displayed.
2 Within 4 seconds, press ENTER.
3 Within 4 seconds, turn MULTI JOG to select one of the dimmer
modes changed cyclically as below.
4 Within 4 seconds, press ENTER.
DIM-OFF DIMMER 1 DIMMER 2
DIMMER 3
“DIM-OFF” mode is the brightest and “DIMMER 3” mode is the
dimmest. In “DIMMER 3” mode, the spectrum analyzer, the
window of the unit top, and the button illumination light off in
addition.
FLASH WINDOW
The window on the top of the unit lights up or flashes while the
unit is being powered on.
To turn off the light of the top window, press s while pressing
CD. To turn back on, repeat the above.
SETTING THE CLOCK
1
Press CLOCK.
When using the remote control, press CLOCK while pressing
SHIFT.
The clock is displayed. (The “:” between the hours and minutes
flashes.)
2
Within 4 seconds, turn MULTI JOG to designate
the hour and the minute.
Turning MULTI JOG changes both the hour and the minute.
f or g is also available in place of MULTI JOG. Holding
these buttons down will vary the time rapidly.
3
Press ENTER or a.
The clock starts from 00 seconds.
To restore an original clock setting
Press CLOCK before completing step 3 to restore the previous
time setting. This cancels any new setting.
To view the clock when another display is in the display
Press CLOCK. The time is displayed for 4 seconds and then the
original display reappears. However, the clock cannot be
displayed during recording.
To switch to the 24-hour standard
Press CLOCK and then press s within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
In the 12-hour standard, “AM 12:00” indicates midnight and “PM
12:00” indicates noon.
If the clock display flashes
If the display flashes when the clock is displayed, it indicates
that the clock has stopped due to a power failure or the removal
of the power cord. The current time needs to be reset.
If the power-economizing mode (page 6) is on, the unit blacks
out when the power is turned off. To view the clock, press CLOCK
so that the time is displayed for 4 seconds.
PREPARATION