Filter
Top Products
BASIC RECORDING
~-
\.
!
This section explains how to record from the tuner, CD player, or
external equipment.
Preparation
● Use Type I (normal) tapes only.
● Set the tape to the point where recording will start.
● Note that recording is done only one side of the tape.
1
Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded on first facing
out from the unit.
2 Press one of the function buttons and prepare
the source to be recorded.
To record from a CD, press the CD button and load the
disc(s).
To record from a radio broadcast, ”press the TUNER button
and tune in to a station.
To record from the connected source, press the VIDEO/
AUX button and play.
3 Press the ● REC/REC MUTE button to start
recording,.
When the selected function is CD, playback and recording
start simultaneously.
To stop recording, press the
■ button.
To pause recording, press the II button. (Applicable when the
source is TUNER or VIDEO/AUX) To resume recording, press
again.
,
INSERTING BLANK SPACES -
4-second blankspacescan be insertedat thedesired pointduring
recording. (Applicable when the source is TUNER or VIDEO/
AUX.)
1 Press the
● REC/REC MUTE button during recording or
while in recording pause mode.
~ on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds; the deck enters the
recording pause mode.
.. .
2 Press the II button to resume recording; -
To insert a blank epace of less than 4 seconds, press the”.
REC/REC MUT.E button again while ~ is flashing.
To insert blank spaces of more than 4 seconds, after the
deck enters recording pause mode, press the
● REC/REC
MUTE button again. Each time the button is pressed, a 4-second
blank space is added.
.
To erase a recording
Make sure the microphone is not connected to this unit.
1 Insert the tape to be erased into deck 2 and press the TAPE/
DECK 1/2 button to display “TP 2.
2 Set the tape to the point where the erasure is to be started.
3 Press the
● REC/REC MUTE button to start the erasure.