Filter
Top Products
7 Press TUNER BAND repeatedly to select the
desired band.
~FM— AMT
When TUNER BAND is pressed while the power is off, the
power is turned on directly.
To select a band with the remote control
Press BAND while pressing SHIFT.
2 Press << DOWN or - UP to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, “TUNE is displayed for 2 seconds.
During FM stereo reception, (l@ll) is displayed.
To search for a station quickly (Auto Search)
Keep 4+ DOWN or - UP pressed until the frequency starts
to change rapidly. After tuning in to a station, the search stops.
To stop the Auto Search manually, press +4 DOWN or ~
UP.
* The Auto Search may not stop at stations with very weak
signals.
When ian FM stereo broadcast contains noise
Press MONOTUNER while pressing SHIFT on the remote control
so that “MONO appears on the display,
Noise is reduced, although reception is monaural.
To restore stereo reception, repeat the above so that “MONO”
disappears.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step, If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press F’OWER while pressing >.
To reset the interval, repeat this procedure,
m
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
The unit can store atotal of 32 preset stations. When a station is
stored, a preset number isassigned to the station. Use the preset
number to tune in to a preset station directly.
1
2
3
Press TUNER BAND to select a band, and press
- DOWN or ~ UP to select a station.
Press 11 SET to store the station.
A preset number beginning from 1 in consecutive order for
each band is assigned to ths station.
Preset ~umber
Repeat steps 1 and 2.
The next station will not be stc)redifa total of 32 preset stations
for all the bands have already been stored.
m
“FULP is displayed if you attempt to store more than 32 preset
stations.
Use the remote control to select the preset number directly.
7 Press BAND while pressing SHIFT to select a
band.
2 Press numbered buttons O-9 and +10 to select a
preset number.
Example:
To select preset number 20, press +10, +10 and O.
To select preset number 15, press +10 and 5,
Selecting a preset number cm the main unit
Press TUNER BAND to select alband. Then, press > PRESET
repeatedly or turn MULTI JOG.
Each time > PRESET is pressed, the next ascending number
is selected.
To clear a preset station
Select the preset number of the station to be cleared. Then, press
❑ CLEAR, and press II SET within 4 seconds.
The preset numbers of all other stations in the band with higher
numbers are also decreased by one,
ENGLISH 9