Filter
Top Products
z-
/
““~heunit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
Press one of the function buttons to select a
source.
● IfTUNER BAND ispressed, the band cannot be selected in
this step.
Press TIMER repeatedly until 0 appears on the
display.
When using the remote control, press TIMER while pressing
SHIFT.
Time and audio source name flash alternately.
a
Within 6 seconds, turn MULTI JOG to designate
the timer-on time, then press ENTER or Il.
Turning MULTI JOG changes both the hour and the minute.
+ or - is also available instead of MULTI JOG. Holding
these buttons down will vary the time rapidly.
Within 4 seconds, turn MULTI JOG to select the
duration for the timer-activated period.
The duration can be set between 5 and 240 minutes in 5
minute steps.
- or E iSalSOavailable instead of MULTI JOG.
5
6
7
Adjust the volume.
The source sound will play at the volume level set in this step
R
when the power is turned on by the timer.
a.
If the volume level is set to 17 or higher, however, it will
j:~j~
;*4JL
automatically be set to 16 when the power is turned on. , ;;l
%
1?! ‘+:
Prepare the source.
,.,.
~,., ~’‘8’
To listento a CD, load the disc to be played first on tray 1.
;$%;
8
,;””~
To listen to a tape, insert the tape into deck 1 or 2.
‘1 ,.
To listen to the radio, tune in to a station.
d
Press POWER to turn off the power.
When the timer-on time is reac:hed~the unit turns on and
begins play with the selected source.
You can change the source thlat was selected in step 1 by
pressing one of the function buttons before pressing ENTER or
II in step 3.
To check the timer setting
Press TIMER.
The selected source, the timer-cm time, and the duration for the
timer-activated period will be displayed for 4 seconds.
To change any of the previous setting
Carry out from step 1.
However, if you do not change the timer-on time, in step 3 just
press ENTER twice and continue from step 4.
To cancel the timer standby mode temporarily
Press TIMER repeatedly so that @ disappears.
To restore the timer standby mode, press again to display ~.
Using the unit while the timsr i:sset
You can use the unit normally after setting the timer.
m
Before turning off the power, carry out step 5 and 6.
m
. Timer playback and timer recording will not begin unless the
power is turned off.
● Connected equipment cannot Ibeturned on and off by the built
in timer of this unit. Use an external timer.
Timer recording is applicable for TUNER and VIDEO/AUX (with
an external timer) sources only.
Press either TUNER BAND or VllJEO/AUX to select a source,
then press TIMER repeatedly until ~ REC appears on the
display. Within 6 seconds, carry out the steps of “SETTING
THE TIMER” from step 3 and insert the tape to be recorded on
into deck 2 after step 6.
m
You cannot use the timer functicm to record from a CD or tape.
The duration will be automatically set after 4 seconds. It will
also be set if ENTER or 11 is pressed within 4 seconds after
step 4.
ENGLISH 17