Filter
Top Products
Power Supply
IMPORTANT
Make sure that FUNCTION is set to (!) STANDBY P~WER/
TAPE before connecting the AC cord or inserting batteries.
Connect the AC cord as illustrated below.
supplied AC cord \~+ @ tO ,an AC outlet
CAUTION
Use
only the supplied AC cord. Use with other cords may
result in the risk of fire.
Open the lid of the battery compartment on the rear and
insert eight RI 4 (size C) batteries, not supplied, with the 0
and
O marks correctly aligned. Then close the lid.
To switch from AC power supply to battery power
supply, disconnect the AC cord from the AC inlet.
When to replace the batteries
The Ol”E/BATT indicator becomes dim, the tape speed
slows down, volume decreases, or sound is distorted during
operation.
Notes on batteries
● Do not mix different types of batteries or old batteries with
new ones.
● When the unit is not to be used for a long period, remove
the batteries to prevent needless battery wear
● Never recharge the batteries, apply heat to them or take
them apart.
● Remove dead batteries.
If Iiquici leaks from the batteries, wipe thoroughly to remove.
To turn off the unit, set FUNCTION to (!) STANDBY
POWER so that the OPE/BATT indicator gee!> out.
If an erroneous display or malfunction occurs,
disconnect the AC cord and remove all the batteries to
turn off the display. Then turn the power back on.
Maintenance
To clean the cabinet
Use a soft cloth lightly moistened with mild detergent
solution. Do not use strong solvents such as alcohol,
benzine or thinner.
To clean the heads and tape
paths
After every 10 hours of use,
clean the heads 0 and 0, the
pinchroller 0 and capstan 0.
Use a cotton swab @ slightly
moistened with cleaning fluid
or denatured alcohol.
To clean the lens
Use a cotton swab slightly
moistened with cleaning fluid.
Wipe gently from the center to
the edge.
Lens
ENGLISH 3