Filter
Top Products
5
4,5
3,7,8,9
In the Programmed edit recording function the tracks can be
programmed while checking the remaining time on each side of
the tape as the tracks are programmed.
1
2
3
4
Insert the tape into Deck 1.
Insert the tape with the side to be recorded on first facing out
from the unit, and wind up the tape with +.
Press CD and load the disc(s).
Press EDIT/CHECK twice while pressing SHIFT
on the remote control.
“EDIT and “PRGM” are displayed.
● When “Al” is displayed, press EDIT/CHECK while pressing
SHIFT again.
Press numbered buttons on the remote control
to designate the tape length.
10 to 99 minutes can be specified.
● -, - or MULTI JOG are also available to designate
the tape length.
Tape side A Maximum recording
Tape length (front side)
time for side A
5 Press one of DISC DIRECT PLAY 1-5 to select a
disc.
Then, press numbered buttons O-9 and +1O on
the remote control to program a track.
To select disc 4 or 5 from the remote control, press DISC
DIRECT PLAY 4 or 5 while pressing SHIFT.
Example: To select the 10th track of disc 2, press DISC
DIRECT PLAY 2, then press +10 and O.
Selected disc
number Program number
Remaining time on side A
I
I
Selected track number
Programmed tracks number
6
7
8
9
Repeat step 5 for the rest of the tracks for side
A.
A track whose playing time is longer than the remaining time
cannot be programmed.
Press
EDIT/CHECK while pressing SHIFT on the
remote control to select side B and program the
tracks for side B.
Tape side B (reverse side)
I
Press EDIT/CHECK while pressing SHIFT to
select side A and press
● on Deck 1.
~
flashes for 10 seconds, and then CD play and recording
of edited tracks for the first side start simultaneously. When
the end of the tape is reached, Deck 1 enters the recording
stop mode. After entering the recording stop mode, go to
step 9.
Press
EDIT/CHECK while pressing SHIFT on the
remote control for recording of the second side.
“B
is displayed.
10 Turn over the tape in Deck 1 and press
● to start
recording.
Recording starts.
To stop recording
Press WA on Deck 1. Recording and CD play stop
simultaneously.
To
check the order of the programmed track numbers
Before recording, press EDIT/CHECK while pressing SHIFT on
the remote control to select side A or B, and press + or ~
repeatedly.
Disc number
Program number
Track number
Programmed track numbers
To change the program of each side
Press EDIT/CHECK while pressing SHIFT on the remote control
to select side A or B, and press
■CLEAR to clear the program
on the selected
side. Then program tracks again.
To
clear the edit program
Press ■ CLEAR twice in stop mode so that “EDIT” disappears
on the display.
13 ENGLISH