Filter
Top Products
6
En
If the video equipment does not have a digital out jack;
Connect the AUDIO OUT jacks of the video equipment to
the VIDEO/AUX jacks of this unit with an optional audio
connecting cord with RCA phono plugs (red plug to the R
jack, white plug to the L jack).
•When connecting an LD player via its AC-3 RF OUT
jack, use an RF demodulator to separate the analog
visual signals and the digital audio signals. Refer to the
Operating Instructions of the LD player.
8
Connect the television to the video equipment.
Refer to the Operating Instructions of the connected
equipment for details.
9
Connect the AC power cord to an AC outlet.
When the AC power cord is connected to an AC outlet for
the first time, DEMO appears on the display.
To deactivate the DEMO, press DEMO/ECO.
•Do not short-circuit the 0 and 9 speaker cord leads.
•Do not leave objects generating magnetism or objects
affected by magnetism near the speakers.
Note on positioning
Allow 10 cm (4 in.) clearance from the top of the unit for the
Window movement when you position the unit.
Remote control
Detach the battery compartment lid at the rear of the remote
control and insert two R6 (size AA) batteries with correct
polarity.
•Replace the batteries with new ones when the operational
distance between the remote control and main unit becomes
shorter.
•Remove the batteries if the unit is not going to be used for
an extended period of time.
•The remote control may not operate if it is used under intense
sunlight, etc., or if its line of sight is obstructed.
Positioning the speakers
To achieve the optimum effects obtainable with the Dolby Digital
or the Dolby Pro Logic system, it is important to position the
speakers properly. Refer to the following illustration to find out
the best location in your room.
L&R: Front speakers
C: Center speaker
Position in the center of the two front speakers. In addition,
position on or below the TV set, if connecting a TV set to the
unit.
LS&RS: Surround speakers
Place the surround speakers directly to the side of or slightly
behind the listening area. Align them horizontally, about 1
meter (3.2 feet) above ear height.
SW: Subwoofer
Place the subwoofer on the floor close to a wall or in a corner
of the room.
•Sound output from the center and the surround speakers is
only available when the Dolby Digital system or the Dolby
Pro Logic system is activated with the appropriate setting.
To mount the surround speakers on the wall
Mount each speaker
on a spot that can hold its weight.
AIWA disclaims any responsibility for injury to persons
or other accidents caused by not fitting the surround
speakers properly or if the place of the installation is not
suitable.