Filter
Top Products
18
En
Subwoofer On or Off mode
If you connect a subwoofer to this unit, change the Subwoofer
mode to "S-W ON". Low-frequency effect signals are sent to
the subwoofer. In "S-W OFF", low-frequency effect signals are
directed to the other speakers.
1
Play the Dolby Surround sound.
2
Press MANUAL SELECT on the remote control.
"S-W OFF" or "S-W ON" is displayed.
3
Press f to display "S-W OFF" or g to
display "S-W ON" to select the desired mode.
•Subwoofer mode setting is common to Dolby Digital and
Dolby Pro Logic.
Adjustments
Speaker level adjustment
The unit is equipped with a built-in test signal generator for
easy balance adjustment of the channels. The test signal
"travels" from channel to channel. Adjust the sound level for
the same apparent loudness from each channel at listening
position.
The left and right front speakers create the stereo effect.
The center speaker helps achieve precise sound positioning over
a broad sound field.
The surround speakers enhance the "depth" of the sound field.
1
Press NORMAL, PHANTOM or 3 STEREO to
select the mode for the speaker configuration (see
"Dolby Surround modes").
On the remote control, press SURROUND repeatedly.
- For playback with the supplied speakers, select
"NORMAL".
2
Hold down MANUAL SELECT on the remote
control until "L" flashes in the display.
The indication for the currently adjustable channel flashes
in the display and the test signal automatically cycles
through the following channels:
- L: The left front speaker
- C: The center speaker
- R: The right front speaker
- RS: The right surround speaker
- LS: The left surround speaker
3
Press f or g on the remote control to
adjust the sound level.
- For the left and right front speakers: Press f to shift
the balance to the left and g to shift to the right.
-
For the center and the surround speakers: Press f
to de-emphasize the channel and g to emphasize
the channel.
•The channel will not change while you are adjusting the
sound level.
•Speaker level adjustment is available only for speakers that
are activated.
•Adjustment of speaker levels is common to Dolby Digital
and Dolby Pro Logic.
•A clicking sound might be heard with the test signal during
level adjustment. This is due to the circuit characteristics
and is not a malfunction.
To stop speaker level adjustment
Press s.
To adjust the speaker level without the test signal
1 Play the Dolby Surround sound.
2 Press NORMAL, PHANTOM or 3 STEREO to select the mode
for the speaker configuration.
On the remote control, press SURROUND repeatedly.
3 Press MANUAL SELECT repeatedly on the remote control
until "L/R" is displayed.
4 Press f or g to adjust the sound level of the front
speakers.
5 Repeat steps 3 and 4 to adjust the sound level of the other
speakers.
To adjust the center speaker level directly on the
remote control
1 Play the Dolby Surround sound.
2 Press SURROUND repeatedly to select "NORMAL" or "3
STEREO".
3 Press CENTER LEVEL + or -.
To adjust the rear (surround) speaker level directly
on the remote control
1 Play the Dolby Surround sound.
2 Press SURROUND repeatedly to select "NORMAL" or
"PHANTOM".
3 Press REAR LEVEL + or -.