Filter
Top Products
En
ENGLISH
9
PREPARATIONS
BEFORE OPERATION
FRONT SPEAKERS A,B
DIMMER
PHONES
POWER
6STANDBY/ON
INPUT MODE
SHIFT
INPUT MODE
DISPLAY
POWER
To turn the unit on
Press POWER 6STANDBY/ON (POWER).
The STANDBY/ON indicator lights in green.
Operation is possible after four seconds. The volume level and
function name are displayed one after the other for the first eight
seconds.
To change the brightness level of the display
Press DIMMER (hold down SHIFT and press
DISPLAY) repeatedly.
The dimmer mode changes as follows.
DIM-OFF
DIMMER 3 (No display)
DIMMER 1 DIMMER 2
DIM-OFF: The normal display
DIMMER 1: The illumination of the display is dimmer than usual.
DIMMER 2: The illumination of the display is dimmer.
DIMMER 3 (no display): Everything on the display is cleared.
NOTE
While in the mode other than DIM-OFF, if you operate the receiver,
the display illuminates at the DIM-OFF level, and after 6 seconds,
the display brightness returns to the level previously set.
Note that "DIMMER" is displayed for one second before
everything is cleared when the previously set level is "no display".
Using the headphones
Connect headphones with a standard stereo plug (ø6.3 mm) to
the PHONES jack. Be sure to turn off the speakers by pressing
FRONT SPEAKERS A and/or B. Otherwise sound is output from
the speakers.
To turn the unit off, press POWER 6STANDBY/ON (POWER).
The STANDBY/ON indicator turns to red.
Turning on the front speaker system A and/or B
To turn on the front speaker system A: press FRONT
SPEAKERS A so that "❘❖3A" is displayed. To turn it off, press it
again.
To turn on the front speaker system B: press FRONT
SPEAKERS B so that "❘❖3B" is displayed. To turn it off, press it
again.
Both systems can be turned on at the same time.
NOTE
• The front speaker system B is for use of 2 channel stereo system
only. When turning on the front speaker system B:
- surround mode or DSP mode is automatically canceled and
cannot be turned on.
-"❘✱❱✤◆❊❊ (sub woofer off) " mode is selected automatically.
• The front speaker system A & B are connected in series.
So the sound cannot be heard if the both speaker systems are
turned on when only one speaker system is connected.
SOURCE DIRECT FUNCTION
You can cancel all the sound adjustments (except the volume),
with their settings kept in memory, to listen to the original source
sound.
Press INPUT MODE once so that "❘✱❈❍◗❉❇❙ " is
displayed.
To restore the sound adjustments, press it repeatedly to display
"❅▼❅❑◆❋ " or "❈❍❋❍❙❅❑ ".
• This function is not activated with the TUNER (FM or AM) and
5.1ch IN functions or with the "❊◗✤❘▲❅❑❑ (front speaker small)"
mode.
• When the source direct function is activated:
- SURROUND, DSP, BASS and TREBLE do not function.
-"❘✱❱✤◆❊❊ (sub woofer off) " mode is selected automatically.
See the next page for the sound adjustments.