Filter
Top Products
• Are the FRONT SPEAKERS A and B buttons set correctly? (
→
page 6)
Sound is emitted from one speaker only.
• Is the BALANCE control set appropriately?
• Is the other speaker disconnected?
Sound is heard at a very low volume.
• Has the MUTING button been pressed?
An erroneous display or a malfunction occurs.
→
Reset the unit as stated below.
TUNER SECTION
There is constant wave-like static.
• Is the antenna connected properly? (
→
page 5)
• Is the signal weak?
→
Connect an outdoor antenna.
The reception contains noise interference or the sound is distorted.
• Is the system picking up external noise or multipath distortion?
→
Change the orientation of the antenna.
→
Move the unit away from other electrical appliances.
To reset
If an unusual condition in the display window or malfunction occurs, reset the unit as
follows.
1
Press the POWER button to turn off the power.
2
Press the POWER button while pressing the SET button.
Everything stored in memory after purchase is canceled.
If the power cannot be turned off in step 1 because of a malfunction, reset by
disconnecting the AC cord and repeat step 2.
PARTS INDEX
Instructions about each part on the unit or remote control are indicated on the pages listed below.
(in alphabetical order)
Parts Pages
AUX/TV 6, 9
BALANCE 7, 13
BBE 7
CD 6, 9
CLOCK 6
DOLBY PRO LOGIC 12, 13
DOWN ( ) 6, 8, 10, 11, 13, 14
DSP 8
FRONT SPEAKERS A, B 6
GEQ 8
MANUAL SELECT (TEST) 8, 13
MONO TUNER 10
MUTING, MUTE 7
PHONES 6
PHONO 6, 9