Filter
Top Products
Set the time as follows while the power is off.
1 Press the SET button.
The hour flashes.
2 Press the DOWN or UP button to designate the hour.
3 Press the SET button to set the hour.
The hour stops flashing and the minute starts flashing.
4 Press the DOWN or UP button to designate the minute.
5 Press the SET button to set the minute.
The minute stops flashing on the display and the clock starts from 00 second.
To correct the current time
Press the POWER button to turn the unit off. Press the SET button and carry out steps 1 to 5 above.
To display the current time
Press the CLOCK button on the remote control. The clock is displayed for 4 seconds.
To switch to the 24-hour standard
Press the POWER button while pressing the UP or DOWN button while the current time is displayed.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes while the power is off.
This is caused by a power interruption. The current time needs to be reset.
If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be
reset.
SOUND pg. 7
CUSTOM AUDIO ADJUSTMENT
VOLUME CONTROL
Turn the VOLUME control on the unit, or press the VOLUME buttons on the remote control.
To adjust the left/right balance