Filter
Top Products
MANUAL TUNING
MONO
TUNER
1
2
L—”——i
I
L--Al
1
u
<......>
Turn the FUNCTION selector to select theTUNER
function, and press the VIDEO 1/5.1 CH/BAND
button repeatedly to select the desired band.
~
The display changes to frequency indications after indicating
band and video source (V1, V2 or V3) for two seconds.
Press the UP or DOWN button to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, “TUNE is displayed for two
seconds. During FM stereo reception, 11{~11]is displayed.
To search for a station quickly (Auto Search)
Keep the UP or DOWN button pressed until the tuner starls
searching for a station. After tuning in to a station, the search
stops.
Tostop the Auto Search manually, press the UP or DOWN button.
● The Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast contains noise
Press the MONO TUNER button on the remote control so that
“MONO appears on the display.
Noise is reduced, although reception is monaural.
MONO
To restore stereo reception, press the button so that “STEREO
appears.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation
system is 9 kHz/step, change the tuning interval.
Hold down the VIDEO 1/5.1CH/BAND button and press the
POWER button.
To reset the interval, repeat this procedure.
13 ENGLISH