Filter
Top Products
MANUAL TUNING
1
2
TUNER/
BAND
+
I
TUNER/
[l-----n
BAND
BAND
Press the TUNER/BAND button repeatedly to
select the desired band.
r
FM -AM
1
( J
If the power is turned off, the previously tuned station will be
played (Direct Play Function).
Press the l++ or
➤>1 button (or the +< / ➤-
button) to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, “TUNE” is displayed for a moment.
During FM stereo reception, [1[~1)) is displayed.
1[1011)
When an
FM stereo broadcast contains noise
Press the MODE TUNER button while pressing the SHIFT button
on the remote control,
“MONO” appears on the display.
Noise is reduced, although reception is monaural,
To restore stereo reception, repeat the above again,
To
change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press the POWER button while pressing the T~JNER/BAND
button,
To reset the interval, repeat this procedure.
m
When the AM tuning interval is changed, all preset stations (see
“PRESETTING STATIONS”) are cleared. The preset stations
have to be set again.
To
search for a station quickly (Auto Search)
Keep the 1<< or ➤>1 button (or the ++ / ➤> button) pressed
until the tuner starts searching for a station. After tuning in to a
station, the search stops,
To stop the Auto Search manually, press the 1<< or
➤>1 button
(or the + /
➤- button),
● The Auto Search may not stop at stations with very weak
signals.
ENGLISH 9