Filter
Top Products
TIMER PLAY
POWER
The unit can be turned on at a specified time every day with the
built-in timer.
Make sure the clock is set correctly. (See page 7.)
Use the remote control.
1 Press theTIMER button repeatedly while pressing
the
SHIFT button on the remote control to display
0.
2 Within 4 seconds, press the 11button.
The hour flashes.
3
4
w
If you do not press the II button within 4 seconds, another
operation may start.
Designate the hour of the timer-on time by
pressing the +< or ➤F button, and press the
1I button. Repeat to designate the minute of the
timer-on time.
Press the 44 or ➤F button to select a source
for timer play, then press the II button.
To listen to a radio broadcast, select “FM” or “AM. ”
You can change the band later at step 6.
To
listen to the equipment connected to theTAPE IN jacks,
select “TAPE.”
To
listen to the equipment connected to the AUX IN jacks,
select ‘rAUX.”
5
6
7
Select the duration for the timer-activated period
the 11
with the 4+ or >> button, and press
button.
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
Prepare the source.
To listen to a CD, load the disc.
To listen to a radio broadcast, select the desired band and
tune in to a station.
To listen to the connected equipment, set the timer of the
connected source (with an external timer) and prepare it for
play.
Press the POWER button to turn the system off
after adjusting the volume and tone.
@
remains on the display after the power is turned off (timer
standby mode).
When the timer-on time is reached, the system turns on and
begins play with the selected source.
If the volume level was set to more than 25 when the power
was turned off, it is automatically set to 25 when the unit turns
on by the timer. m
To check the specified time and source
Press the TIMER button while pressing the SHIFT Ibutton on the
remote control, The selected source name, the timer-on time
and the duration for the timer-activated period are displayed for
4
seconds.
To cancel timer standby mode temporarily
Press the TIMER button repeatedly while pressing the SHIFT
button on the remote control so that “NO TIMER” is displayed
on the display.
To restore the timer standby mode, press again to display ~.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, repeat step 6 to prepare the source,
and adjust the volume and tone.
m
● Timer play will not begin unless the power is turned off.
● Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
ENGLISH 13