Filter
Top Products
7
ENGLISH
PRESETTING STATIONS
0-9, +10
d DIR/
PRESET
2
s
1
BAND
1
The unit can store a total of 32 preset stations (Each band has a
maximum of 20 available preset stations). When a station is
stored, a preset number is assigned to the station. Use the preset
number to tune in to a preset station directly.
1
Press TUNER/BAND to select a band, and press
ff
ff
f or
gg
gg
g to select a station.
2
Press
aa
aa
a to store the station.
A preset number beginning from 1 in consecutive order for
each band is assigned to the station.
Frequency Preset number
3
Repeat steps 1 and 2.
The next station will not be stored if a total of 32 preset stations
for all the bands or a total of 20 preset stations for one band
have already been stored.
PRESET NUMBER TUNING
Use the remote control to select the preset number directly.
1
Press BAND to select a band.
2
Press numbered buttons 0-9 and +10 to select a
preset number.
Example:
To select preset number 10, press +10 and 0.
To select preset number 15, press +10 and 5.
Selecting a preset number on the main unit
Press TUNER/BAND to select a band. Then, press d DIR/
PRESET repeatedly.
Each time d DIR/PRESET is pressed, the next ascending
number is selected.
To clear a preset station
Select the preset number of the station to be cleared. Then,
press s, and press a within 4 seconds.
The preset numbers of all other stations in the band with higher
numbers are also decreased by one.
MANUAL TUNING
BAND
2
1
POWER
MODE
1
Press TUNER/BAND repeatedly to select the
desired band.
FM AM
When TUNER/BAND is pressed while the power is off, the
previously tuned station will be played (Direct Play Function).
To select a band with the remote control
Press BAND repeatedly.
2
Press
ff
ff
f or
gg
gg
g to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, “TUNE” is displayed for 2 seconds.
During FM stereo reception, “1” is displayed.
TUNE
1
To search for a station quickly (Auto Search)
Keep f or g pressed until the frequency starts to change
rapidly. After tuning in to a station, the search stops.
To stop the Auto Search manually, press f or g.
• The Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast contains noise
Press MODE on the remote control so that “MONO” appears on
the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button again so that
“MONO” disappears.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press POWER while pressing TUNER during power on.
To reset the interval, repeat this procedure.
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
RADIO RECEPTION
05-08/XR-M150<U>/Eng 10/4/2000, 5:07 PM7