Filter
Top Products
EnEn
EnEn
En
ENGLISH
4
EE
EE
E
(Españo(Españo
(Españo(Españo
(Españo
FF
FF
F
(França (França
(França (França
(França
CONNECTING SPEAKERS1
Speaker terminals
Connect front speakers (system A and/or B) and sub woofer to
the corresponding speaker terminals on the unit:
- the front speaker cords to the SPEAKERS terminals
- for more powerful bass, the sub woofer (with a built-in amplifier)
cord to the SUB WOOFER 3 jack
Speaker impedance
For all speakers, use speakers of 8 ohms or more.
Connecting + to +, – to – terminals
To get the proper sound effect, the speaker terminals on the unit
and the speaker should be connected with proper polarity; the +
terminal on the unit should be connected to the + terminal on
the speaker (and – to –).
NOTE
• The sub woofer sound will be output only when the speaker
system A (the front speakers connected to the SPEAKERS A
terminals) is selected.
• Be sure to connect the speaker cords correctly as shown in
the illustration on the right column. Improper connections can
cause short circuits in the SPEAKERS terminals.
• Do not leave objects generating magnetism near the speakers.
PREPARATIONS
1 and 2 in the illustration correspond to the following details.
Lift up the terminal flap, insert the speaker cord lead
into the terminal slot, then close the flap. Check that
the cord is connected securely.
1
Speaker system B
Right Left
1
Speaker system A
Right Left
1
Sub woofer
2
FM antenna
2
AM antenna