Filter
Top Products
21
ENGLISH
TIMER
SETTING THE CLOCK
When the AC cord is connected for the first time, the clock on
the display flashes.
Set the time as follows while the power is off.
1 Press the ENTER button.
The display becomes a little brighter.
2 Within 4 seconds, turn the MULTI JOG to
designate the hour and the minute.
The time advances by turning it to the right, and decreases
by turning it to the left.
The N or M button on the main unit is also available. Press
the button repeatedly. To change the time rapidly in 10-minute
steps, hold it down.
3 Press the ENTER button.
The clock starts from 00 seconds.
NOTE
When the clock is set for the first time after purchase
Everything on the display will clear.
This is because the power economizing mode of the unit is
activated, and is not a malfunction.
The power economizing mode can be canceled. See page 7 for
details.
To correct the current time
Press the POWER button to turn the unit off. Carry out steps 1
to 3 above.
To display the current time
Press the CLOCK button on the remote control. The clock is
displayed for 4 seconds.
When the power is off in the power economizing mode, pressing
the ENTER button on the unit also displays the current time for 4
seconds.
To switch to the 24-hour standard
Display the current time, and press the DIGITAL/ANALOG/BAND
button on the unit within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
In the 12-hour standard, “AM 12:00” indicates midnight and “PM
12:00” indicates noon.
If the clock display flashes while the power is off
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours, all
settings stored in memory after purchase need to be reset.
ON SCREEN DISPLAY
The receiver provides an “On Screen Display” function to show
the receiver settings on the TV screen. With the TV turned on,
when you operate the receiver buttons or remote control buttons,
the settings appear on the TV screen as well as the receiver
display. The following are examples of the “On Screen Display.”
When turning on the receiver, pressing the function
buttons, or tuning in a station
On the right side of the screen, the setting results appear for 5
seconds.
When pressing audio effect buttons such as SURROUND,
DSP, GEQ, T-BASS, BBE and MANUAL SELECT
On the left side of the screen, the audio effect settings appear
for 5 seconds.
When pressing CLOCK or SLEEP buttons on the remote
control
On the left side of the screen, the timer setting and the present
time appear for 5 seconds.
NOTE
• The receiver provides an “On Screen Display” function only
when the TV is connected to the MONITOR VIDEO (S VIDEO)
OUT jack.
• When connecting the S VIDEO OUT and VIDEO OUT terminals
at the same time, the unit outputs the OSD data only through
the S VIDEO OUT terminal.
ON SCREEN DISPLAY
Video
V
I
DEO 1
Audio
FM
ON
TAPE OFF
MUT
I
NG
TUNER FREQ
87.50M
Hz
“MUTING ON” continues flashing
until MUTING mode is set to off.
VOL 1
0
PRO LOG
I
C OFF
DSP
OFF
OFF
OFF
OFF
MAX
MAX
LVL
LVL
L
R
GEQ
T
-
BASS
BBE