Filter
Top Products
EnEn
EnEn
En
ENGLISH
18
EE
EE
E
(Españo(Españo
(Españo(Españo
(Españo
FF
FF
F
(França (França
(França (França
(França
ADJUSTING DOLBY DIGITAL
SURROUND SOUND
ADJUSTING LOW FREQUENCY SOUND
EFFECT(LFE)
The disc recorded in Dolby Digital surround contains special
signals called LFE to enhance low frequency sound effect. The
LFE signals are recorded in some particular parts on the disc
and output from the connected sub-woofer to reproduce
astonishingly powerful low sound.
The sound level of the LFE signals can be adjusted according to
your speakers connected while the Dolby Digital surround is
activated.
Preparation
• When connecting a sub-woofer, select “SUBW ON”
(see page 5).
• Play a disc recorded in Dolby Digital Surround.
1 Press the N(UP) or M(DOWN) button and hold
it down until “LFE” is displayed.
2 Press the N (UP) or M (DOWN) button
repeatedly or turn the MULTI JOG to adjust the
LFE level.
The unit is initially set to 0 dB (maximum) and can be adjusted
as shown below.
When selecting “SUBW OFF”, the LFE signals are redistributed
to other speakers.
ADJUSTING DYNAMIC RANGE
Dynamic range of the Dolby Digital surround sound can be
adjusted. The unit is initially set to the “STD” (standard) mode.
1 While the Dolby Digital surround is activated,
press the ENTER button and hold it down until
“MID NIGHT THEATER” runs through on the
display.
2 Press the N(UP) M(DOWN) button or turn the
MULTI JOG to select the “MAX,” “STD” or “MIN”
mode.
[MIN]
You can enjoy the full dynamic range sound like in the movie
theater.
[STD]
Original position, when playing back in home, that is
recommended by the software producers.
[MAX]
Select this mode when playing back at low volume. This is
the mode used with the midnight setting.
DOLBY SURROUND AND
DTS SURROUND