Aiwa NSX-MT241 CD Player User Manual


 
-._, .. _______ —— -
The clock is displayed. (The “:” between the hours and minutes
flashes.) When the power cord is plugged into an AC outlet for
the first time after purchase or when the clock setting is canceled
due to a power failure, the entire clock display flashes.
1
2
3
Press 11 or ENTER.
When using the remote control, press CLOCK.
Within 4 seconds, turn MULTI JOG to designate
the hour and the minute.
Turning MULTI JOG changes both the hour and the minute.
+ or > is also available instead of MULTI JOG. Holding
these buttonsdown will vary the time rapidly.
Press II or ENTER.
The clock starts from 00 seconds.
To restore an original clock setting
Press CLOCK on the remote control before completing step 3 to
restore the previous time setting. This cancels any new setting.
To view the clock when another display is in the display
Press CLOCK on the remote control. The time is displayed for 4
seconds and then the original display reappears. However, the
clock cannot be displayed during recording.
To switch to the 24-hour standard
Press CLOCK on the remote control and then press
within 4
seconds.
Repeat the same procedure to restore the 12-hour standard.
~
If the display flashes when the clock is displayed it indicates
that the clock has stopped due to a power fadure or the removal
of the power cord. The current time needs to be reset.
m
If the power-economizing mode (page 8) is on, all the display
lights turn off when the power is turned off. To view the clock,
press II or ENTER so that the time is displayed for 4 seconds.
The unit can be turned off automatically at a specified time.
Use the remote control.
1
2
Press SLEEP.
Within 4 seconds, turn MULTI JOG to specify the
time until the power is turned off.
The time changes between 5 and 240 minutes in 5-minute
steps.
u
While the timer is in operation, the display indication is dimmer
and > are also available instead of MULTI JOG.
Specified time
than usual.
To check the time remaining until the power is turned off
Press SLEEP once. The remaining time is displayed for 4
seconds.
To cancel the sleep timer
Press
SLEEP twice so that “SLEEP oFF appears on the display.
20 ENGLISH