Filter
Top Products
I
1,8 L-
B
f“
—. ...— —.-
3,7
5
The Al edit recording function enables CD recording without
worrying about tape length and track length. When a CD is
inserted, the unit automatically calculates the total track length.
If necessary, the order of tracks is rearranged so that no track is
cut short.
(Al: Artificial Intelligence)
m
Al edit recording will not start from a point halfway into the tape.
The tape must be recorded from the beginning of either side.
1
2
3
4
5
Insert the tape into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
Press CD and load the disc(s).
Press CD EDIT/CHECK once on the remote
control,
“EDIT” is displayed.
EDIT
● When “PRGM” is displayed, press CD EDIT/CHECK again.
Press DISC DIRECT PLAY 1-3 to select a disc.
Press numbered buttons O-9 on the remote
control to designate the tape length.
10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press 6 and O.
[n a few seconds, the tracks to be recorded on each side of
the tape are determined.
● -, - or MULTI JOG are also available to designate
the tape length.
Programmed tracks
Remaining time
for side A
of recording
6
7
8
Press ● REC/REC MUTE to start recording on
the first side.
The tape is rewound to the beginning of the first side, the
lead segment is played through for 10 seconds, and recording
starts. When the last track programmed for side A is finished,
deck 2 enters the recording stop mode. After entering the
recording stop mode, go to step 7.
Press CD EDIT/CHECK on the remote control to
display the program for the second recording.
“B” is displayed.
Turn over the tape in deck 2 and press ● REC/
REC MUTE to start recording on the second side.
To stop recording
Press
■ . Recording and CD play stop simultaneously.
To clear the edit program
Press
■ CLEAR twice so that “EDIT” disappears on the display.
To check the order of the programmed track numbers
Before recording, press CD EDIT/CHECK on the remote control
to select side A or B, and press + or > repeatedly.
Programmed
track numbers
Track number
Tape side
Program number
To add tracks from other discs to the edit program
If there is any time remaining on the tape after step 5, you can
add tracks from other discs in the CD compartment.
1 Press CD EDIT/CHECK on the remote controlto select side
A or B.
2 Press DISC DIRECT PLAY 1-3 to select a disc.
3 Press numbered buttons on the remote control to select tracks.
A track whose playing time is longer than the remaining time
cannot be programmed.
4 Repeat steps 2 and 3 to add more tracks.
Time on cassette tapes and editing time
The actual cassette recording time is usually a little longer than
the specified recording time printed on the label. This unit can
program tracks to use the extra time. When the total recording
time is a little longer than the tape’s specified recording time
after editing, the display shows the extra time (without a minus
mark), instead of the time remaining on the tape (with the minus
mark).
m
The Al edit recording function cannot be used with discs
containing 31 tracks or more. ‘(TR OVER” is displayed if this is
attempted.
1
Tape length
Tape side
Minus mark
A: First recording side
B: Second recording side
16
ENGLISH