Filter
Top Products
| ADCOM GTP-602 Owner’s Manual8
9ADCOM GTP-602 Owner’s Manual |
Use a twin RCA-to-RCA lead to con-
nect the CD player’s left and right
‘Audio Outputs’ to this input.
[
9
] Auxiliary Analog Inputs
Input for any line-level signal source.
Use a twin RCA-to-RCA lead to con-
nect the CD player’s left and right
‘Audio Outputs’ to this input.
[
10
] Tape Inputs/Outputs
Connections for analog recording and
playback to an audio tape recorder
of any type, such as a cassette, reel-
reel, DAT, MD or CD-R. Using twin
RCA-to-RCA leads, connect to the
left and right ‘Audio Output’ of the
tape machine to the TAPE IN connec-
tors for playback. Connect the left
and right ‘Audio Input’ of the tape
machine to the TAPE OUT connectors
for recording.
[
11
] Phono Inputs
Input for a phono (record) player
(analog audio signal) Use a twin RCA-
to-RCA lead to connect the phono-
player’s left and right ‘audio outputs’
to this input.
[
12
] IR Input
The IR input allows hook up of an
external IR sensor that sends IR infor-
mation to the microprocessor in the
GTP-602. This feature can be very use-
ful if the GTP-602 is placed behind a
non transparent door or is used with an
after market remote control system.
[
13
] 12V DC Trigger
To facilitate remote turn-on and
turn-off of other components (power
amplifiers, for example), this 3.5mm
mini-jack provides a constant signal
(12 volts DC) whenever the GTP-602
is fully powered. When the GTP-602 is
turned off (via the front panel switch)
or placed in standby mode (via the
“power” button on the remote con-
trol), the jack has no output.
[
14
] Main Audio Outputs
Before making any connections, check
that the GTP-602 and the power
amplifiers it will be connected to are
switched off. Connect the RCA-to-RCA
leads from the GTP-602 to your exter-
nal amplifiers. The three pairs of out-
puts all carry the same signal.
[
15
] RS232 Control (DB 9)
Allows control of the GTP-602 via com-
puter or home automation system.
[
16
] Power Switch
The rear panel power switch should
be turned off if the system will not be
in use for an extended period of time.
When the power switch is in the off
position the GTP-602 is not using any
power from the AC wall circuit. This
switch must be on for the GTP-602 to
operate in the “stand-by” mode.
[
17
] AC Power Cord
After you have completed all con-
nections to the amplifier, plug the AC
line cord into a “live” wall socket.
Use only the supplied power cord or
equivalent.