Filter
Top Products
| ADCOM GTP-602 Owner’s Manual6
7ADCOM GTP-602 Owner’s Manual |
RDS Tuner Overview
FM/AM Button: Toggles between AM
and FM frequency bands.
FM mode Button: Sets the FM tuner
to mono mode. The word mono
appears next to the tuner preset
number in the front panel display.
Pressing the button again returns the
FM tuner to stereo mode.
memory Button: This button is used
to program preset stations. See the
instructions following for more infor-
mation.
tune/preset button: This button
toggles the tuner between the direct
tuning mode and the preset selection-
mode.
Up and Down Buttons: The func-
tion of these buttons depends on the
tuning mode selected with the tune/
preset button.
In preset mode (indicated in the
display area): Press the down button
to scroll to a lower number preset;
press the up button to scroll to a
higher preset number. This is a “wrap-
around” function, so that going from
the highest number preset, the tuner
will go to the lowest preset number
or vice-versa when tuning either up
or down.
In tune mode: Press the up or down
button to adjust the frequency cur-
rently being received. You can also
press and hold the buttons to make
faster adjustments.
The GTP-602 tuner can receive AM,
FM and FM stereo broadcasts. Up
to 24 stations can be preset and
accessed from the front panel or
remote. Stations can also be tuned
manually.
NOTE: Tuner reception cannot take
place unless an appropriate AM and/
or FM antenna is connected to the
rear panel of the GTP-602.
To operate the tuner:
1. Press the tuner button on the
remote control once, or press the
tuner button on the front panel.
2. Press the AM/FM button on the
remote control or the front panel to
change between AM and FM bands.
3. Use the tune buttons on the front
panel or the remote to change the
tuner frequency. The new frequency
will be displayed to the right of the
FM or AM indicator.
4. Press and hold either the tune
buttons on the front panel or on the
remote to scan continuously up or
down the selected band.
5. Press the FM mode button on the
front panel to toggle between stereo
and mono.
If an FM station produces lots of noise
or sound that cuts in and out while
in stereo, use the FM mode button to
switch from stereo to mono.
To preset a radio station into
memory:
1. Tune to the radio station you desire.
2. Press and hold the mem button on
the remote or the memory button on
the front panel for 3 seconds to store
a station into a preset location. The
display will change to show the word
“memory” along with a flashing num-
ber.
3. Use the up or down buttons to
select the preset number that you
wish program. This programs the cur-
rent radio station to that memory
location. You have approximately five
seconds to enter a number.
Listeneing to a radio station that
you have preset:
1. Set the GTP-602 to tuner.
2. Use the keypad on the remote
control to select the preset that you
want to hear.
The tuner frequency changes to the
new station in the preset memory of
the GTP-602.
To change a preset radio station:
1. Tune to the new radio station you
desire.
2. Press and hold the mem button on
the remote or the memory button
on the front panel. The display will
change to show the word “memory”
along with a flashing number.
3. Enter the new preset/memory
location (01 through 12) using the
keypad on the remote or the up and
down buttons. This replaces the pre-
viously memorized preset with your
new selection. You have approxi-
mately five seconds to enter a num-
ber.