Filter
Top Products
E-8
Which radio aerial?
Your Arcam T32 is capable of superb radio reception, but only if it is receiving a good
quality transmission signal.
e T32 is tted with an FM/AM receiver and an optional DAB+ receiver, depending
on the region where it was sold. e type of aerial you need depends on your listening
preferences and the local conditions.
Try the aerials supplied with your unit. If you are in a medium to strong signal area,
these should be adequate for good reception. In an area of weak reception, or for
optimum performance, an external aerial may be required. Contact your local Arcam
dealer or an aerial installation expert for advice.
DAB
In moderately strong signal areas, one of the two
dipole ribbon aerials supplied can be used with
reasonable results.
1. Loosen the two cross-head screws on the push-on
adaptor.
2. Slide a terminal tag from the long end of the
ribbon aerial under one of the screws and tighten
securely. Repeat with the other tag and remaining
screw.
3. Attach the push-on adapter to the F-type
DAB
connector on the back panel of the unit.
4. e ‘T’ section of the aerial should be mounted
vertically, since DAB signals are vertically
polarised.
When installed and receiving DAB, check the signal
strength by pressing the
INFO button on the front panel
or remote until the signal bar graph is displayed.
In weak signal areas, a high-gain, externally-mounted
or roof-mounted aerial is desirable in order to receive
the highest number of services.
In Band III transmission areas (such as the UK), use a
multi-element Yagi aerial with the elements mounted
vertically, as the transmissions are vertically polarised.
If you are close to more than one transmitter, use an
omnidirectional or telescopic dipole aerial.
If the DAB services in your area are transmitted on
L-band, then ask your dealer for advice for the best
aerial to use.
VHF/FM
DAB
antenna