E-16
Continual improvement policy
Arcam has a policy of continual improvement for its
products. is means that designs and specications
are subject to change without notice.
specications
FM section
Tuning range 87.5 to 108.0MHz
Frequency steps 50kHz
Sensitivity (IHF) typically 4µV
Signal to noise ratio 65dB at full modulation, 1kHz
THD+n 0.3% at full modulation, 1kHz
AM section
Tuning range 530 to 1710 kHz; 10kHz step
531 to 1602 kHz; 9kHz step
Usable sensitivity typically 20µV
IF rejection > 32dB
S/N ratio (30% mod., 50mV input) > 42dB
Total harmonic distortion (30% mod., 50mV input) < 1.5%
Output level 270mV at 30% modulation
DAB section (where fitted)
Tuning range: 174–240MHz (Band III)
1452–1492MHz (L band)
Sensitivity (VHF measurement to EN50248) better than -91dBm, typically -97dBm
Audio data rate (maximum) 224kbits/s at MPEG protection level 3
Sirius section (where fitted)
Specications are determined by SiriusConnect module
Control inputs
IR remote standard Philips RC-5, 36kHz carrier
IR in signal level 4–15V pk-pk
General
Supply voltage 110–120V or 220–240V, set by rear panel voltage
selector switch
Power consumption 15W maximum; standby power 1W
Presets 100 presets, with14 presets accessible from front panel
preset buttons
Size W430 x D290 x H85mm
Weight nett: 5.3kg/packed: 6.8kg
Supplied accessories FM dipole aerial
DAB dipole aerial (DAB version only)
AM loop aerial
mains lead
CR90 remote control handset
4 x AAA batteries
E&OE
NOTE: All specication values are typical unless otherwise stated