Filter
Top Products
AVR280
34
IR Remote Codes
The following information is supplied for owners of advanced programmable remote controls, such as the
Philips ‘Pronto’ and similar devices, where it is possible to program remote codes directly into the device.
The coding system for the AVR280 is based on the Philips RC-5 standard. The main system control uses
RC-5 system codes ‘16’, with the tuner section using system code ‘17’ (this is to provide compatability
with existing ARCAM tuners). So, for example, to program in a ‘Stand-by’ command, use the command
‘16-124’.
Zone 2 also uses RC-5 system code 16 as standard, as Zone 2 is normally operated in a separate room
using a standard (system code 16) remote control.
Main system control code, system code 16. Items shown in THIS STYLE indicate the equivalent remote
control button of the supplied CR100 remote control.
Command Command code Command Command code
Stand-by 124
MODE
32
On 123 Mono mode 106
Zone 1 stand-by 125 Stereo mode 107
Power toggle 12 Dolby PLII Movie 108
Display (DIS) 59 Dolby PLII Music 109
Menu (MENU) 82 (Reserved) 102
Info 55 Dolby PL Emulation 110
DTS Neo:6 Cinema 111
Mute 119 DTS Neo:6 Music 112
Un-mute 120 Dolby PLIIx Movie 103
Mute toggle (MUTE) 13 Dolby PLIIx Music 104
Volume up 16 (Reserved) 105
Volume down 17
Effect (FX) 70
SAT input 0 Effect off 63
AV input 2 Effect: Music 64
TUNER input 3 Effect: Party 65
DVD input 4 Effect: Club 66
TAPE input 5 Effect: Hall 67
VCR input 6 Effect: Sport 68
AUX input (AUX) 8 Effect: Church 69
CD input 7
DVD-A input 9 Trim menu (TRM) 37
Sub trim menu (SUB) 51
Stereo Direct on 78 Lip sync. (SYN) 50
Stereo Direct off 79 Setup menu (SETUP) 84
Stereo Direct toggle 10
Satellite video 19
Up 86 AV video 20
Down 85 DVD video 22
Left 81 Tape video 23
Right 80 VCR video 24
OK 87 Video standard 126
Zone 2 on from Zone 1 47 Preset/Tune down (P-) 57
Zone 2 off from Zone 1 48 Preset/Tune up (P+) 56
Preset/Tune mode toggle 54