Filter
Top Products
C31/P35/P1
E-8
C31/P35/P1
E-9
English
Using the remote control
NOTE: Remember to install the two AAA batteries
supplied before trying to use your remote control.
Do not place anything in front of the FMJ badge on
the top left of the C31 (where the IR receiver is
located), or the remote control may not work.
CR-389 Remote Control
The CR-389 remote control gives access to all functions
available on the front panel of the C31. It also has
controls to operate Arcam CD players and tuners.
FM DAB
PROG DISP
RPT
MODE BAND
1-9 2-10 3-11
FM
DAB
SEL
TUNER
CR-389
CD
AMPLIFIER
VCRDVD TAPEAV
TUNERCDAUXPHONO
ENTER
SP1
SP2
DISP
MENU DISP
4-12
5-13 6-14 7-15 8-16
*
+
(UP and DOWN)
These buttons are used in the con guration menu
and have the same effect as turning the control
knob. Pressing
*
is the same as turning the
control knob clockwise,
+
is the same as turning
the knob anticlockwise.
SEL (Select)
Performs same function as the SELECT button on
the front panel. It allows you to use the remote’s
volume switch in the same way you use the
control dial on the front panel – to adjust various
ampli er settings (see page 8).
Pressing + corresponds to turning the control knob
clockwise, – to anticlockwise.
Source selection buttons
These operate in the same way as the source
selectors on the front panel of your C31.
Power/Stand-by
Toggles the C31 between stand-by mode and full
power mode. The power indicator light on the front
panel is red if the C31 is in stand-by, amber while
it is powering-up (this takes only a few seconds)
and green when the C31 is operational.
SP1 and SP2
These buttons are for use with the P35 ampli er,
to allow you to select and deselect the main (SP1)
and secondary (SP2) sets of speakers attached to
it (see page 14 for further information).
DISP (display)
Cycles through the settings ‘Off’, ‘Dimmed’ and
‘Bright’. Turning the display ‘Off’ may give a slight
improvement in sound quality.
Volume and
-
(mute)
Press + to increase volume or – to decrease the
output volume of the ampli er.
Press
-
to mute the pre-amp outputs of the
C31. Note that both recording outputs will remain
active. Mute is disabled by either pressing
-
again, or adjusting the volume.
CD controls
These offer basic control of Arcam CD players.
If you wish to use the same
remote control for both your C31
and your DT91 tuner, please use
the CR-389D remote control shipped
with the tuner (instead of the
remote control described here).
TUNER
These buttons are used to control Arcam tuner
functions.
Note that the FM/DAB lights indicate into which
mode you are switching the remote control. The
lights only illuminate for ve seconds to conserve
battery power.
If neither light is illuminated this does not mean
that the remote control is not working.
ENTER
Performs the same function as the ENTER button
on the front panel (see page 8).