Filter
Top Products
E-45
English
is displayed and audio is muted. If you have any queries
about your subscription, please contact Sirius.
Operation
In addition to the channel and preset selection,
previously mentioned, you can also cycle through the
station categories (Rock, Pop, Country, etc.) using the
]
and
[
keys. e rst station in each category is
displayed. You can then scroll through other stations in
that particular category using the
D
or
E
buttons on
the CR102 remote. On the OSD a star (‘ * ”) is shown
before the category name to show you are scrolling
through stations only in the current category. Press
O
to select the currently displayed station to listen to
it otherwise the display times out and returns to the
currently playing station information.
Locking Channels
e Sirius module in the AVR600 has a parental lockout
feature which allows you to assign a 4-digit code to any
stations you do not wish to be generally available to
users.
Channels can be locked out individually by pressing and
holding the
MODE key. ‘Lock?’ also appears on the lower
line of the On Screen Display. Pressing
O
conrms and
applies the parental lock to the channel and the display
returns to the channel name.
If a locked channel is selected, the audio will be muted
and the user prompted on the display to enter the
unlocking code. ‘Unlock code :____’ is displayed.
e default unlock code is 0000.
If the code is entered correctly the audio for this channel
unmutes. If the code is not entered correctly, the
previously played channel is re-selected.
To remove the parental lock from one of the locked
channels (so that the unlocking code is no longer
required to listen to them), navigate to the channel,
select it and enter the unlocking code to unmute the
channel. Press and hold the
M
key until the display
shows ‘Unlock ?’. Press
O
to remove the lock from the
channel.
NOTE
e locking code is reset to 0000 if a factory reset of
the AVR600 is performed.
Sirius errors
If an invalid channel is selected, the AVR600 displays
‘INVALID CHANNEL’ and the channel reverts to the
previous valid channel.
If there is a loss of signal, the AVR600 displays
‘ACQUIRING SIGNAL’.
If the antenna is disconnected, the AVR600 displays
‘ANTENNA ERROR’.
During the channel map update, the message ‘Updating
channels - xx%’ is displayed. Note that audio is
muted until the update is complete. When complete, the
AVR600 retunes to the original channel and restores the
audio.