Filter
Top Products
E-12
Connection guide
DVD player
e diagram shows how to make audio and video
connections from a typical DVD player.
e preferred video hook-up, in order of preference is:
<
use the HDMI connector (if HDMI output is
provided by the player), otherwise connect the three
Component or four RGB+Sync video connectors.
<
use the S-Video connection if HDMI or Component
/RGB+Sync outputs are not provided by your player.
<
use the Composite connection if HDMI,
Component/RGB+Sync or S-Video are not provided
by your player.
In each case, connect the video inputs labelled
DVD on
the AVR600.
e preferred audio hook-up is using the coaxial digital
connector (usually marked
DIGITAL AUDIO OUT), in
addition to the coaxial analogue outputs for le and
right channels.
In each case, use the audio inputs labelled
DVD on the
AVR600.
Satellite receiver
A satellite receiver is connected in the same way as
a DVD player, with the same order of preference
according to the outputs provided by the satellite
receiver.
In each case, use the inputs labelled
SAT on the AVR600.
Note that digital audio input from a satellite receiver
sometimes requires a coaxial/TOSLINK (digital
connector) interconnect cable, as some satellite receivers
do not implement audio over HDMI properly or at all.
CD player
Connect the digital audio output (if provided by the CD
player) to the digital CD input of the AVR600, using a
high quality coaxial interconnect cable.
Connect the right and le analogue audio outputs of
the CD player to the analogue
CD inputs of the AVR600,
using a pair of high quality coaxial interconnect cables.