Model TER46WOW
Setting the clock
Oven
Automatic c/o&
Right front
Start
Minute Timer
stop
Oven light
temperature
Oven control
time time
switch
control
selector knob
I I
Left front
Left rear
I \
I
\
Surface
Oven Riaht rear
Surface unit
control control
knob knob
‘heating”
“heating ”
Eontral
indicator
signal light
signal light knob
Using the surface units
Push in
and turn
Control knobs must be pushed in before
turning them to a setting. They can be set
anywhere between HI and OFF.
Surface unit indicators
The solid dot in the surface unit indicator
shows which surface unit is turned on by
that knob.
Surface heating signal light
The Surface HEATING Signal Light on the
control panel will glow when a surface unit
is on.
Burn and Fire Hazard
Be sure all control knobs are turned
to OFF and all signal lights are OFF
when you are not cooking. Someone
could be burned or a fire could start
if a surface unit is accidentally left
ON.
Until you get used to the settings, use
the following as a guide. For best results,
start cooking at the high settings; then turn
the control knob down to continue cooking.
Use HI to start foods cooking; to bring
liquids to a boil.
Use MED-HI to hold a rapid boil; to fry
chicken or pancakes.
Use MED for gravy, puddings and icing;
to cook large amounts of vegetables.
Use MED-LO to keep food cooking after
starting it on a higher setting.
Use LO to keep food warm until ready to
serve. Set the heat higher or lower within
the LO band to keep food at the
temperature you want.
Use only flat-bottomed utensils for best
cooking results and to prevent damage to
the cooktop. Specialty items with rounded
or ridged bottoms (woks, ridged bottom
canners or tea kettles) are not
recommended.
Burn and Product Damage Hazard
l
If the pan is too small for the
surface unit, you could be burned
by the heat from the exposed
section of the surface unit. Use
correctly sized cooking utensils to
prevent injury.
l
If a surface unit stays red for a
long time, the bottom of the pan is
not flat enough or is too small for
the surface unit. Prolonged usage
of incorrect utensils for long
periods of time can result in
damage to the surface unit,
cooktop, wiring and surrounding
areas. To prevent damage, use
correct utensils, start cooking on
HI and turn control down to
continue cooking.
Push in and turn the Minute Timer Knob
to set the Clock.
1. Push in Minute Timer Knob and turn
clockwise until clock shows the right
time of day.
2. Let the Minute Timer Knob pop out.
Turn clockwise until Minute Timer hand
points to OFF. The clock setting will
change if you push in the knob when
turning.
Using the Minute Timer
The Minute Timer does not start or stop the
oven. It works like a kitchen timer. Set it in
minutes up to an hour. You will hear a
buzzer when the set time is up.
Do not push in the knob when setting
the Minute Timer.
1. Without pushing it in, turn the Minute
Timer Knob until the timer hand passes
the setting you want.
2. Without pushing in, turn the knob back
to the setting you want.
When the time is up, a buzzer will
sound. To stop the buzzer, turn the
Minute Timer hand to OFF.
NOTE: Pushing in and turning the Minute
Timer Knob changes the clock setting.
Page 4
