2.
For best results, wipe off
surface units
with a damp sponge and soapy water
after each use.
Remove
burned-on food
with
a
soap-filled scrubbing pad.
Rinse
well. The red spot in the center of the
surface unit will gradually wash off. This
is normal and will not affect the operation
of the surface unit.
NOTE:
Make sure plastic scrubbing pad
does not contain metal or abrasive
particles. Do not use abrasive cleaners.
3. IMPORTANT: Dry
the element com-
pletely after cleaning.
Turn on
the
element for a few minutes to dry thor-
oughly.
After the element has cooled,
use a
paper towel to apply a thin coat of
sak-free oil to the surface units to season
and restore the finish.
Wipe excess
oil off
black trim rings. Then
heat 3-5
minutes.
Some smoking may occur; this is normal.
If surface units have dark spots caused
by grease and food, the oil treatment will
improve their appearance, but not elimi-
nate the spots.
Optional: You
can apply ElectroP
dressing to the surface units to improve
their appearance.
To order information for ElectroP
Dressing (Part No. 814030) write to:
Whirlpool Corporation
Attention: Customer Service Department
1900 Whirlpool Drive
LaPorte, IN 46350
OR
Call 1-800-253-1301 to order. You must
have a major credit card to order by phone.
34
