A SERVICE OF

logo

4 Replacement Procedures 4.26 LCD unit & FL inverter
10. Remove the following screws securing the LCD unit holder.
M2.5x4.0S FLAT BIND screw x8
4-62 [CONFIDENTIAL] TECRA M4 Maintenance Manual (960-521)
M2.5x4.0S FLAT BIND
M2.5x4.0S
FLAT BIND
Figure 4-40 Removing the LCD unit holder
11. Pull up the FL inverter while peeling off the double-sided tape.
CAUTION: The removed FL inverter is not reusable. Therefore when installing the FL
inverter, it must be a new one.
12. Disconnect the inverter harness and remove the FL inverter from the display cover.
FL inverter
Inverter harness
Figure 4-41 Removing the FL inverter