3-5
3
1
Press the key and press .
2
Press to select “02.TCP/IP”.
NETWORK
01.COMPLETE
02.TCP/IP
03.NETWARE
3
Press to select “01.BOOTP/DHCP”.
BOOTP/DHCP
1.ENABLE
2.DISABLE
4
To enable the BOOTP/DHCP, press to select
“1.ENABLE”.
To disable the BOOTP/DHCP, press to select
“2.DISABLE”.
• The display returns to the TCP/IP menu.
TCP/IP
01.BOOTP/DHCP
02.IP ADDRESS
03.SUBNET MASK
5
Press the key.
• The display returns to the NETWORK menu.
• If you want to change another TCP/IP network setting,
change the setting before pressing the key.
NETWORK
01.COMPLETE
02.TCP/IP
03.NETWARE
6
Press to select “01.COMPLETE”. Save
the network settings and start initializing.
• After 2 seconds, the Operation Completed message is
displayed and returns to the INITIAL SETUP menu. It may
take few minutes to finish initializing the Network Interface
Card.
• If you want cancel the TCP/IP setting, press the key
before selecting “01.COMPLETE”.
NETWORK
Initializing
NETWORK
Operation completed
INITIAL SETUP
02.LANGUAGE
03.TERMINAL ID
04.NETWORK
TCP/IP
01.BOOTP/DHCP
02.IP ADDRESS
03.SUBNET MASK
04.DEFAULT GATEWAY
05.HOST NAME
BootP/DHCP Setting
