23
HT-CN300W_A_4.fm02/7/11
HT-CN300W
Basic Operation
- Display control / Sound control -
Display control
„
To change the display brightness (2 levels)
You can switch the brightness of the main unit display by pressing the DIMMER
button.
„
TV screen display
By pressing the DISPLAY button whilst in the DVD or VIDEO mode, you can check
the status or setting on the TV screen.
Caution:
This unit can display on the TV its current speaker and mode settings when in the
DVD or VIDEO mode, but not if connected to the TV via an S-video cable. This
function is only available via the Video cable connection.
Sound control
„
Volume control
Press the VOLUME button to increase the volume and the VOLUME button for
decreasing.
„
Bass control
When the X-BASS button is pressed, the unit will enter the extra bass mode which
emphasises the bass frequencies. To cancel the extra bass mode, press the X-BASS
button.
„
Equaliser
When the EQ button is pressed, the current mode setting will be displayed. To
change to a different mode, press the EQ button repeatedly until the desired sound
mode appears.
Note:
Bass control and equaliser are enabled only when the sound mode is set to
"STEREO" or "VIRTUAL" (see page 26).
Dimmed (Dimmer mode) Brightened
Example: TV screen display
Bass frequencies are
emphasised.
Cancelled.
FLAT The sound is not modified.
ROCK Bass and treble are emphasised.
POPS Bass and treble are slightly emphasised.
JAZZ Treble is cut a little.
CLASSIC Treble is reduced a lot.
VOCAL Vocals (midrange tones) are emphasised.
210 29 30 MAXIMUM
.....
Main unit
TV screen
Main unit
TV screen
