![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/5/0c/50c09dcb-8e6e-4d0e-a992-97c82555cf52/50c09dcb-8e6e-4d0e-a992-97c82555cf52-bg11.png)
16
HT-CN300W_A_3.fm02/7/11
HT-CN300W
Remote Control
- Preparing the remote control -
Preparing the remote control
„
Battery installation
You can operate the remote control with batteries in areas where the AC power lead
cannot reach.
Precautions for battery use:
z
Replace all old batteries with new ones at the same time.
z
Do not mix old and new batteries.
z
Remove the batteries if the unit is not to be used for long periods of time. This will
prevent potential damage due to battery leakage.
Caution:
z
Do not use rechargeable batteries (nickel-cadmium battery, etc.).
z
Installing the batteries incorrectly may cause the unit to malfunction.
Notes concerning use:
z
Replace the batteries if the operating distance is reduced or if the operation
becomes erratic. Purchase 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar).
z
Periodically clean the transmitter on the remote control and the remote control
sensor with a soft cloth.
z
Keep the remote control away from moisture, heat, shock, and vibrations.
„
Test of the remote control
Point the remote control directly at the remote sensor.
The remote control can be used within the range shown below:
z
Press the ON/ (STAND-BY) button. Does the power turn on? Now, you can enjoy
your system.
z
When the signal is received, the remote control indicator will flash. Whilst in the
dimmer mode (page 23), it will not flash or light.
Note:
Exposing the remote sensor to strong light may interfere with operation. Change the
lighting or the direction of the remote control sensor.
„
How to open the remote control cover
To access the Memory 1/2 buttons, open the remote control cover.
Note:
You can control the DVD, VCR, etc. with this remote control (see page 19).
1
Turn the remote control over and place it on a soft cloth.
2
Open the battery cover.
3
Insert the batteries according to the direction indicated in the
battery compartment.
When inserting or removing the batteries, push them towards the battery
terminals.
4
Close the cover.
0.2 m - 6 m
(8" - 20')
Remote sensor
Remote control
indicator
15
15
20
20