Reception Features
28
2
TSI Print
Usually the sender's TTI is printed on
received messages. If the sender has
not programmed their TTI, you will
not be able to identify them. However,
if you turn this feature on, the sender's
RTI or CSI is printed instead so you
can find out where the message came
from. See Chapter3, “G3 Analog
Line“ in the Basic Features manual.
Note
❒ You can turn it on or off with the
User Parameters. ⇒ P.130 “Changing
the User Parameters”(Switch01, Bit5)
CIL/TID Print
The optional ISDN Unit is required.
Two features are provided for identi-
fication of messages received by G4
(ISDN). If turned on, this information
will be printed on every page.
The CIL (Call Identification Line) re-
fers to the combination of the receiv-
er's own fax number, name, the
sender's own fax number and name,
time, and page number. The default
setting is on. The TID refers to the
name registered by the sender in their
TTI. The default setting is off.
Limitation
❒ These features are available only
when receiving in G4 mode.
❒ If the sender's TID contains dou-
ble-byte characters (for example
Chinese characters), the TID will
not be printed even if TID Print is
turned on.
Note
❒ You can turn CIL and TID on or off
with the User Parameters. ⇒ P.130
“Changing the User Parame-
ters”(Switch02, Bit5 or Bit6)
FAX Print Color
You can specify a color for any re-
ceived message, list on report. You
can choose the color of toner from
Black, Cyan, Magenta.
Limitation
❒ The color specified for 2nd Color
Choice cannot be used as a on FAX
Print Color.
Note
❒ By default, the color of toner is
Black. You can change the color
with INITIAL Setup RX.
2nd Color Choice
If this feature is specified, the ma-
chine can print with 2nd Color when
the machine has run out of default
toner. It is useful that the 2nd toner
use as a reserve of toner.
Limitation
❒ The color specified for FAX Print
Color cannot be used as a on 2nd
Color Choice.
❒ If the machine has run out of 2nd
Color, there is no additional substi-
tution.
Note
❒ By default, 2nd Color is not speci-
fied. You can turn it on and select
the color with INITIAL Setup RX.
