A SERVICE OF

logo

Open as PDF
next previous
COLOR DOME CAMERA User Guide
10
COLOR DOME CAMERA User Guide
11
Installation
Installation
Adjust the panning, tilting and rotate mechanism while checking the position on the monitor
1. Remove the dome cover and inner cover from the main body by loosening the three
dome cover screws.
2.
And then remove the main body from the mounting bracket by the four main body screws.
MountingBracket
MainBody(Camera)
DomeCover
InnerCover
73°
-170°
145° 195°
170°
PanBase
Tilt Base
RotateBase
•Theinstallationshouldbedonebyqualifiedservicepersonnelorsysteminstallers.
•Iftheceilingmaterialisnotstrongenoughtoholdtheinstallationscrews,thecamera
mayfalloff.Reinforcetheceilingasneeded.
•Takecarenottodroptheproductduringinstallation.Donotallowanyonetostand
belowtheinstallationarea.
Notes
You can adjust camera to any direction by using the Pan, Tilt, Rotate mechanism.
•PanBasemovesby170°ineachdirectionor340°intotal.
•TiltBasecovers73°ineachdirectionor146°intotal.
•TheanglerangeoftheRotateBaseisthesameasthatofthePanBase.Butone
directionrangeis195°andanotheris145°
Methods of adjustment
•Wallinstallation
After mounting the camera to the wall, loosen the rotate base holding screws.
Adjust to the correct panning angle.
Then adjust the tilt angle by rotating the base.
Once complete re-tighten the rotate base holding screws.
•Ceilinginstallation
After mounting the camera to the ceiling, loosen the rotate base holding screws.
Adjust to the correct panning angle.
Then adjust the tilt angle by rotating the base.
Once complete re-tighten the rotate base holding screws.
•
Whenadjustingtherotatingangle,loosenrotatebaseholdingscrewasfollowsFigures.
Thentightenitagain.
•Whenadjustingthetiltingangle,gripthetiltbaseandadjusttiltingangle.
•Whenadjustingthepanningangle,loosenpanbaseholdingscrewsasshownbelow
andthenre-tighten.
Notes
•WhenadjustingthetiltmechanismholdtheTiltbaseandNOTthelens.
RotateBaseHoldingScrew
PanBaseHoldingScrew RotateBaseHoldingScrew