A SERVICE OF

logo

Open as PDF
next previous
11
Instructions For Assembly Of Combination Rifle/Shotgun (cont’d)
4. Now that the barrels have been locked into the receiver, you must reattach the forend to the barrels. Place
the forend on the front curve of the receiver (the angle between the forend and barrels should be about 20
degrees). Keeping the contact between forend and receiver with an upward swing motion lock the forend
into the barrels. While it may be necessary to push the latch into its final flat position, never force the latch
into the position. (See
Picture 20).
5.
WARNING: Never fire the gun unless the barrels are locked into position on the receiver and the forend
is locked into the receiver and barrels.
6. Make sure the trigger block safety is engaged after completion of assembly (Red Dot covered).
(See
Picture 21).
Picture 20
Picture 21