10
Instructions For Assembly Of Combination Rifle/Shotgun
WARNING
B
efore you begin to assemble the shotgun, you MUST (1) look down the barrel from the breech end toward the muzzle end to make sure there
i
s no ammunition in the chambers or obstruction in the barrels, and (2) make sure the safety is in the “safe” position.
Your combination rifle/shotgun was shipped with the barrel assembly (barrels and forend) detached from the
receiver assembly. To assemble the combination rifle/shotgun, follow these instructions:
1. Remove the plastic bags or wrapping covering the parts. Then remove the forend from the barrel by
pulling outward on the mechanical lever in the lower midsection of the forend and tipping the forend out
and away from the barrel. (See
Picture 16).
2. Now push the top lever of the receiver to the right and
hold with one hand. Do not force the top lever. (See
Picture 17).
3. Holding the barrels with the other hand, engage the
lower locking lug located on the lower portion of the
barrels with the receiver. The half-round cut out on the
lower locking lug fits around the round bar in the for-
ward lower portion of the slot in the receiver. With the
barrels engaged into the receiver, swing the barrels up
into the locked position. The top lever should move
back into the center once the barrels are locked in the position.
Note: The top lever may not move completely to the center on a new combination rifle/shotgun until the
gun is broken in. The top lever must move at least three quarters of its full travel distance.
(See
Pictures 18 and 19).
Picture 16
Picture 18 Picture 19
Picture 17
