Printing Discs on a PC 17
centered when printed on a CD. To do this, refer to the
following steps:
1. Verify that a disc and a color ink cartridge are installed
in the Printer. It is important to use the same disc you
normally use for your publishing because different brands
of discs may vary slightly in size. Also, verify that the
Printer is powered ON and that it is connected to your
computer.
2. Click on the Center the Print Image and then the
Properties button. The printer will begin printing the
calibration test print.
3. When the print is complete, rotate disc 180ยบ and
put the disc back in the input bin and repeat
step 2 using the same disc.
4. When the second run of the print is complete, you should
have a test print that looks similar to the following:
5. Along the Vertical axis of the printed disc, find the number
whose lines touch. For example, in the above illustration,
Enter the number 2 into the Vertical box of the Calibration
window and 0 for the Horizontal axis.
-5 -4 -3 -2 -1 0 1 2 3 4 5
5 4 3 2 1 0 -1 -2 -3 4 -5
Horizontal Calibration
Find and enter the number
whose lines tough
(must be the SAME number)
Vertical Calibration
Find and enter the number
whose lines tough
(must be the SAME number)
NOTE:
After printing this image
once, rotate this CD
so the ARROWS point
to the BACK of the printer
and print again.
-5
-4
-3
-2
-1
0
1
2
3
4
5
5
4
3
2
1
0
-1
-2
-3
-4
-5
BACK
BACK
510921PM.qxd 1/25/2007 8:52 AM Page 17
