A SERVICE OF

logo

Open as PDF
next previous
4-4 Basic Operations
Scanning Bar Codes
Your printer may have a built-in scanner.
When you scan depends on the way your printer is configured. It will
most likely prompt you on the display to press a certain key (probably the
trigger). When you press it, you activate the scanner.
To scan a bar code:
1. Attach the safety strap to your wrist.
2. Point the scanner at a slight angle approximately 4 – 8 inches from
the bar code symbol.
3. Press the trigger or other key specified by your System Administrator.
CAUTION: Do Not stare into the beam.
The laser scan LED lights green after a successful scan. It lights amber
after an unsuccessful scan. This light is at the upper right of the keypad,
to the left of the On/Off key.