A SERVICE OF

logo

Open as PDF
next previous
1-4 Getting Started
7. Place the keypad/terminal’s power supply into the
tray under the shelf with the three-pronged end
facing the cut-out in the back of the tray.
8. Through the back of the tray, plug the three-hole
end of the keypad/terminal’s cable into the three-
pronged outlet in the keypad/terminal’s power
supply (18-24V).
9. Lay the keypad/terminal’s cable with the L-shaped
connector on the shelf.
10. Place the keypad/terminal on the shelf, but do not
remove the tape from the Velcro at this point.
WARNING
The printer’s power supply uses a different
voltage than the keypad. To connect the wrong
power supply could permanently damage the
keypad or the printer.
Keypad/
Terminal’s
power
cable with
L-shaped
connector
Keypad/Terminal’s Power Supply