1)
➢
DO NOT plug in until assembly is
complete.
➢
Turn ON-OFF switch OFF.
➢
Remove two (2) handle screws
provided.
➢
Position handle as shown in
illustration.
➢
When installing the handle, firmly
press the handle onto the body.
Secure with handle screws provided.
➢
Insert screw.
➢
Tighten screws.
2)
➢
Make sure the quick release upper
cord hook is in the upright position.
➢
Remove the wire tie from the power
cord.
➢
Lock the power cord into the locking
notch base by pressing it into the
quick release upper cord hook as
shown.
Note: This helps keep the power cord out
from under the vacuum cleaner agitator.
3)
➢
Wrap the power cord around the upper
and lower cord hooks and lock the
power cord plug onto the power cord.
